Home Sentinel VI 450 Owner's Manual - page 9
9
1. To enter set-up mode for on-screen programming press and
hold the left button( Broadcasting and Intercom Button )for
2 seconds when the handset is “ on the hook “ . You will hear
a chime before entering Set-up mode.
2. Press the left and right button on the monitor to select the item,
and the middle button to alter or make a change to the menu,
such as the time, date, Gray level settings, cameras that
are Active or off. A fast flash of the memory status LED
reminds you to adjust the clock. The back-up battery to the
clock lasts 4 hours when there is a power failure.
Note:Gray Level indicates Memory image quality
LO (17) for Lower resolution 17 Picture image capacity
HI (13) for higher resolution 13 Picture image capacity
3. Reset handset to End Setup Mode
1. Visitor Calls From Camera Unit
• After 4 seconds of the call, the system will grasp the
picture memory automatically
• After the call, if the handset remains on the hook the
system will cutoff after 30 seconds
• If the handset is picked up, you have 90 seconds
to communicate before it automatically cuts off or hang-up
to terminate a call
• If the memory status LED flashes slowly it means the
images are captured in the memory
2. Audio & Video Monitoring
• Press the right button for monitoring a camera
• Press button again to switch monitoring channel ( If there
is more than one camera connected)
• Reset the handset to end the monitoring mode
System Set-Up
Operation