HoMedics ME Instructions for use manual - Using Your Meˉ System
GB
homedics.co.uk
11
Using your meˉ system
Skin Sensitivity test
Before using the system for the first time, choose a small area close to the area you intend to treat,
for the purpose of performing a skin sensitivity test. Follow the treatment instructions below. You may
see redness in the treated area. This is normal and should disappear within 24 hours. After the skin test,
wait 30 minutes and check your skin for any reaction. Choose the eloˉs setting that did not result in any
reaction when performing a complete treatment.
Preparing for treatment
WARNING: Do Not use the system in a wet environment.
1.
Select an area in your home that is well lit - to reduce discomfort from light flashes emitted from the
device during treatment.
2.
If you have visible hair in the treatment area, remove it with a razor or electric shaver.
3.
Clean your skin and make sure it is hair-free, entirely dry and free from oily substances (lotions,
creams, deodorants, tanning creams and sunscreens).
Note: Device will not operate properly above 86°F (30°C)
Setting up your meˉ for use
Note: Please watch the video at www.memyelos.com before you use the system for the first time.
1.
Clean the eloˉs cartridge light output window with an alcohol-based wet wipe or soft tissue. This
step is important to avoid spreading germs (cross contamination) if more than one person uses
the cartridge.
2.
Connect the power cable into the meˉ system.
3.
Place the meˉ system on a low table or area near a wall outlet - free from any other cords or
objects.
4.
Make sure the applicator is placed in the cradle as shown in figure 1 (page 5).