HoMedics ME Instructions for use manual - Treatment
HOMEDICS
meˉ
14
GB
Treatment
1.
Gently remove the applicator from the base.
2.
Press the eloˉs activation button located on the side of the applicator.
3.
With the thumb and forefinger of your hand, gently hold the applicator by the top and bottom grip
sensors.
4.
Place the applicator on your skin so that the two RF delivery bars are in complete contact with the
skin.
Do Not apply continuous pulses (one on top of the other)
with the applicator staying in any one spot on your skin
during treatment!
Do Not overlap the flashing light pulses as you move from
one area of the skin to the next! Stop treatment if the
treated area feels too hot or burns.
5.
Once the applicator is in the correct position, the system will start flashing bright light pulses. With
every flash, move the applicator to the next adjacent spot over the skin either by “lifting and
placing” from spot to spot or gliding in one continuous, slow motion. Avoid overlap between
adjacent pulses.
Do Not return to a previously treated spot for at least 10 seconds!
6.
Repeat treatment to entire area 3-4 times according to the approximate times in the Quick
Reference Guide. Wait 10 seconds or more between treatments to the same area.
Note: The applicator will automatically turn itself off if no pulses have been emitted for one continuous minute.
Tips:
•
When using the meˉ system on difficult to treat areas (e.g. underarm) apply the applicator in 2
directions: left/right and up/down for full coverage.
•
You can treat all body areas during the same treatment session.
correct
incorrect
skin surface
skin surface
both RF
delivery bars
are in contact
with the skin