I-O Display Systems i-glasses User Manual - page 2
2/5/02
2 of 2
SVGA User Manual
Set up your computer:
The SVGA Personal Display system works best when the video source is a VGA
(640 x 480) or SVGA (800 x 600) format at 60Hz. To set your PC to these settings,
see below:
1.
SET MONITOR TO
800
X
600
PIXELS
– In Windows, click on the “Start” button,
on the Windows taskbar, select “Settings,” then “Control Panel,” then
“Display.” The “Display Properties” pop-up screen will appear. Click on the
“Settings” tab at the top right. Make sure your monitor screen area (lower
right) is set to “800
X
600 pixels.” If you have changed the resolution, click the
“Apply” button to accept the change.
2.
SET COLOR RESOLUTION
–
You may want to adjust the number of colors
shown in the color box to improve the quality of their appearance. Color
should be set to a minimum of 16-bit resolution (High Color).
3.
SET THE REFRESH RATE
– Set the refresh rate to 60 Hz. In Windows NT and
Win2000, this is done from the same screen as the resolution setting. For
Windows 95/98/ME, go to the “Settings” tab as outlined above and press the
“Advanced” button, then click on the “Adapter” tab when it appears. Set the
refresh rate to 60Hz. If you have changed the refresh rate, click the “Apply”
button to accept the change.
4.
CLOSE THE DISPLAY PROPERTIES WINDOW
– After accepting the changes to
resolution and refresh rate, close the display properties window.
5.
DISCONNECT MONITOR IF YOU HAVE ONLY ONE VGA PORT.
Screen Shot from Windows NT-Resolution is contained in “Desktop Area” and should be set to 800
x 600. Refresh Frequency should be set to 60Hz.