I-O Display Systems i-glasses User Manual - page 4
2/5/02
4 of 4
SVGA User Manual
Connect your HMD to any Desktop, Laptop, or other VGA source
1.
CONNECT VGA SOURCE
–Connect the video source plug into your VGA output
port.
2.
CONNECT POWER SUPPLY
– Connect the power supply plug into the power
source jack. Plug power cube into an AC socket.
3.
CONNECT AUDIO
– Connect the audio plug into your audio source jack. This may
be the audio output jack from your computer. This is required only if you wish to
hear sound. Otherwise you may leave it disconnected.
4.
CONNECT CABLE TO HMD
– Firmly seat cable connector into headset header,
located above the left eye display.
COMPUTER
(REAR VIEW)
VGA OUT
SOUND CARD OUTPUT
TO WALL SOCKET
4
1
2
3
Using the SVGA Personal Display
1.
TURN ON YOUR PERSONAL DISPLAY
–
Press the power button. T
his will illuminate
the LED next to the button and within a few seconds the display will show your video.
Your SVGA Personal Display unit has been preset at the factory and no further
adjustments should be necessary.
2.
ADJUSTING AUDIO
–If you have an audio source, you can increase or decrease the
volume level using the Up/Down buttons.
3.
ADJUSTING VIDEO OR AUDIO BALANCE
–If you need to make video or audio balance
changes to your unit, please see “Using the OSD” below.