I-SENS AutoChek t Owner's Booklet - Note:
www.i-sens.com 26
A test result will appear after the meter counts down
from 5 to 1.
After your control solution result appears on the display,
press the
▼ for 3 seconds until the ‘check’ icon
appears on the display. When the ‘check’ icon is
displayed, the result is not stored in the meter’s
memory and is not included in the averages.
Compare the result displayed on the meter to the range
printed on the test strip vial. The result should fall within
the range on the test strip vial.
Used strips should be discarded and disposed.
Note:
The meter may be turned off, if the blood sample is not applied within
2 minutes of the icon appearing on the screen.
If the meter is turned off, remove the strip, reinsert, and start from step 1.
Step 3
Step 4
Caution:
• If the results you get are not within this range, the meter and test strip
may not work properly. Then, stop using the meter and contact the
nearest i-SENS representative.
• The range printed on the test strip vial is for the AutoChek t
Control Solution only. It does not have any connection to your
blood glucose level.