I-SERV 8630 Operation Manual - page 22
Version 0.3
Page | 22
Reset settings
The handset name can be reset to default settings by selecting menu “Settings → Reset settings”. The
base is not reset to default when selecting this feature. The handset is still registered after a reset.
Status
The menu “Status” delivers some useful information to the end user. The displayed information’s are:
Base station:
- Software version
- Hardware version
- IP address
- MAC address
- System name
Handset status:
- Software version
- Hardware version
- DECT band
- Battery level
- IPEI
Auto answer
The feature “Normal”, “Any key” and “Automatic” can be selected via menu “Settings → Auto
answer”.
Normal:
The user must always press “Green-key (Off-hook) to answer a call. The call is not answered by
removing the handset from the cradle/charger.
Any key:
Pressing any key will answer an incoming call. The call is not answered by removing the handset from
the cradle/charger.
Automatic:
If the feature “Automatic” is enabled on the handset, then the incoming call is answered automatic
after 5 seconds.
Silent charging
The feature “Silent charging” can be set by selecting menu “Settings → Silent charging”. Handset must
be placed in charger in order to work as mentioned below. The options of silent charging are:
Off:
The handset is ringing when receiving incoming calls (audio alert and incoming call screen displayed).
Disconnect:
The handset doesn’t react on incoming call (no audio alert and no incoming call screen displayed).
Silent:
The handset reacts on incoming call but the handset doesn’t ring (no audio alert but the incoming call
screen displayed).
Do not disturb
The feature “Do not disturb” can be set by selecting menu “Settings → Do not disturb”. When disabled
the handset reacts on all incoming activity, when enabled the handset do not react.