I-Sotec Auxgate Connect Manual manual - page 11
B User’s Guide i-soamp-4cx
B.1. OPERATING THE EQUIPMENT FOR THE FIRST TIME
1. Turn on the radio with the volume set at low.
2. After checking the operation of the individual loudspeakers, set the volume of
the radio a little higher. If appropriate, now use the level adjuster of the power
amplifier to adjust the basic volume of the loudspeakers. The volume ratio of the
front and rear loudspeakers as well as the subwoofer can now be adjusted with
the corresponding level adjusters (see operating elements).
B.2 OPERATING ELEMENTS and CONNECTIONS
1. Undervoltage indicator (low batt.) YELLOW
2. Excess temperature indicator (temp.) RED
3. Power indicator (radio ON) GREEN
4. System plug for power, loudspeaker input and output
5. Remote input for connecting to the i-soamp-MM. Use of the remote input
(Rem.) is optional. Normally the i-soamp-4cx is switched on with the radio
amplifier. In connection with other amplifiers or with a radio, that cannot
switch on the i-soamp-4cx, or if the RCA-sockets are used, this input is nee-
ded to switch on the i-soamp-4cx.
6. Loudspeaker control front
7. Loudspeaker control rear or subwoofer in the front + subwoofer operating
mode
8. RCA Input front/left
9. RCA Input front/right
10. RCA Input rear/left
11. RCA Input rear/right
12. Selector switch for operating mode
B Bedienung i-soamp-4cx
B.1 Erste Inbetriebnahme
1. Schalten Sie das Radio mit kleiner Lautstärke ein.
2. Nach der Funktionskontrolle der einzelnen Lautsprecher stellen Sie eine
etwas höhere Lautstärke am Radio ein. Justieren Sie jetzt gegebenenfalls mit-
tels der Level-Einsteller der Endstufe die Grundlautstärke der Lautsprecher ein.
Das Lautstärkeverhältnis von Front- und Rear-Lautsprechern, sowie dem
Subwoofer lässt sich nun mit den entsprechenden Level-Einstellern (siehe
Bedienelemente) justieren.
B.2 Bedienelemente und Anschlüsse
1. Betriebsanzeige (Radio ON) GRÜN
2. Unterspannungsanzeige (Low Batt.) GELB
3. Übertemperaturanzeige (Temp.) ROT
4. Systemstecker (Strom, Lautsprecher Ein- und Ausgänge)
5. Remote Eingang. Die Benutzung ist optional. Im Normalfall wird der i-
soamp durch den Radioverstärker angeschaltet. In Verbindung mit anderen
Verstärkern oder Radios, die den i-soamp nicht einschalten können, sowie
beim Anschluss über Cinch-Kabel wird dieser Eingang dafür benötigt.
6. Lautstärkeregler Front
7. Lautstärkeregler Rear oder Subwoofer in der Front + Subwoofer Betriebsart
8. Cinch-Eingang Vorne Links
9. Cinch-Eingang Vorne Rechts
10. Cinch-Eingang Hinten Links
11. Cinch-Eingang Hinten Rechts
12. Wahlschalter für Betriebsart
D
UK