I WARM 730 User And Installation Manual - page 16

I

NSTALLATION OF FLOOR

MOUNTING TEMPERATURE SENSORS

(Fig. 6)

Installation of floor temperature sensors is performed

when heating mat or section is being installed. In each area

its own temperature sensor is installed. The sensors installa

tion is performed via a junction box. The sensors are placed

in corrugated plastic tube. The end face of the tube is to be

sealed to prevent penetration of tile fixing mixture or cement

mortar in the course of heated floor arrangement. The end of

the corrugated tube with a sensor inside is placed approx.

50 cm away from the wall, at the height of the heating cable

centrally located between loops. If required the plastic tube

can be placed within a channel in the floor to minimize overall

height. It is recommended that the temperature sensor is

placed through the corrugated tube in the event access is

required to the floor sensor.  Should the floor sensor cable

require extending this is possible up to a maximum of

25 metres.

16