IAG ICS6SE3 Installation and operation manual - page 10
ACS6SE2 and ICS6SE3 60cm Cooktop Installation and Operation Manual
- 10 -
Sealing tape
Carefully turn the hob upside down and place it on a cushioned mat. Apply the sealing strip
provided around the edge of the appliance (see below picture). The protective covering must be
removed from both sides. Do not leave a gap in the sealing agent or overlap the thickness.
IMPORTANT: Do not use a silicon sealant to seal the appliance against the benchtop. This will
make it difficult to remove the hob from the benchtop in future, particularly if it needs to be
serviced.
Affixing cooktop to benchtop
Place the clamp (B) over the holes that match the size of the screws. There are one set of screw
holes in each corner of the hob. Slightly tighten a screw (C) through the clamp (B) so that the
clamp is attached to the hob, but so that you can still adjust the position of it.
Carefully turn the hob back over and then gently lower it into the aperture hole that you have cut
out.
On the underneath of the hob, adjust the clamps into a position that is suitable for your worktop.
Then fully tighten the screws (C) to secure the hob into position.