IAG ICS6SE3 Installation and operation manual - page 12
ACS6SE2 and ICS6SE3 60cm Cooktop Installation and Operation Manual
- 12 -
MY APPLIANCE IS NOT WORKING PROPERLY
The cooking zones are not functioning or will not switch on.
★
Check that the mains electrical supply to the appliance is correct and working. Check the mains
fuse.
A humming sound is heard when a cooking zone is selected.
★
This is normal; the sound will disappear when the zone heats up.
The cooking zones have become discoloured
★
This maybe caused by burnt on remnants of food. This will not affect the working of the appliance.
However you should make sure that the cleaning instructions are being followed regularly.
Only two of the zones on my hob are working
★
You should recheck that the terminal screws are all fully tightened between the links.
IMPORTANT: If your appliance appears not to be operating correctly, then you
should disconnect it from your mains supply and then contact the Service
Department .
DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF.
Please note that if an engineer is asked to attend whilst the product is under guarantee and finds
that the problem is not the result of an appliance fault, then you may be liable for the cost of the
call out charge.
The appliance must be accessible for the engineer to perform any necessary repair. If your
appliance is installed in such a way that an engineer is concerned that damage will be caused to
the appliance or your kitchen, then he will not complete a repair.
This includes situations where appliances have been tiled in, sealed in with sealant, have
wooden obstructions placed in front of the appliance, like plinths.