IAG ICS6SE3 Installation and operation manual - page 6
ACS6SE2 and ICS6SE3 60cm Cooktop Installation and Operation Manual
- 6 -
Hob surface layout
Using the hob
Before first use
IMPORTANT: You should clean the hob surface and solid element plates (see “Cleaning
and maintenance” section).
You should switch on one cooking element at a time, for 5 minutes at the maximum setting.
This will help to eliminate any new smell that exists and evaporate any humidity that has
formed on the heating elements during transit.
When doing this burn off process, an appropriately sized saucepan containing cold water
should be placed on the zone in question.
Do not burn off more than one element at once.
Control knobs
All operations are performed by means of the 4 control knobs that can be found on the right
hand side of the hob top.
The control knobs can be turned either clockwise or anti‐clockwise to select a heating level.
The numbers around the outside of each control knob indicates the power level that you have
set the zone to.
A marking to the bottom right of each control knob, indicates which zone that it controls.
1500 watt
thermostatic
element
2000 watt
thermostatic
element
2000 watt
thermostatic
element
Control knobs
1500 watt
thermostatic
element
On / Off
indicator