IBall baton iB-WRA300N3GT User Manual - page 23
300M Wireless-N ADSL2+ 3G & Broadband Router iB-WRA300N3GT
18
The following table describes the parameters in this page:
Field
Description
VPI
Virtual path identifier (VPI) is the virtual path between two points in
an ATM network. Its valid value is in the range of 0 to 255. Enter
the correct VPI provided by your ISP.
VCI
Virtual channel identifier (VCI) is the virtual channel between two
points in an ATM network. Its valid value is in the range of 32 to
65535. (0 to 31 is reserved for local management of ATM traffic)
Enter the correct VCI provided by your ISP.
Encapsulation
You can select
LLC/SNAP
or
VC-Mux
. In this example, the
encapsulation mode is set to
LLC/SNAP
.
Connection
Mode
There are five WAN connection types:
PPPoA
,
PPPoE
,
IPoE
,
1483 Routed
, and
Bridge
.
PPPoE/PPPoA: Need to enter PPP username and password
provided by your ISP.
IPoE/1483 Routed: You can select
Attain IP Automatically
or
IP Manually
.
Bridge: You need to dial-up on PC to connect to the Internet.
IP Protocol
You can select it from drop-down list:
Default Route
Enable or disable it.
DNS Settings
You can select
Set DNS Automatically
or
Set DNS Manually
. If
you select
Set DNS Manually
, enter DNS server provided by your
ISP.
For other entries which are not mentioned above, you can keep them as defaults.
Step 2
Wireless Quick settings
In following page, you can select wireless band, set SSID and encryption. For wireless
security, it is recommended to set the encryption mode to WPA2, and then enter a
password.