Ibanez Troubadour Owner's Manual - page 9
7
EN
G
LI
SH
Names and Function on Each Part
Front Panel
1.POWERLED:ThisLEDwilllightwhenamppowerisactivatedby
the power switch.
2.INPUT LEVEL: Switches the signal level from MIC INPUT, line
level or mic level.
3. PHANTOM ON/OFF: Switches the phantom power ON/OFF. The
phantompowercansupply+15Vtoyourcondensermicrophone
that connects with MIC INPUT. When you use this switch, turn
downtheVOLUMEto0.
4.MIC INPUT: Balanced input terminal with XLR Jack. 1-GND,
2-HOT,3-COLD.
5. INST. INPUT: 1/4” phone jack input.*
1
6.CLIPINDICATOR:WhenthisLEDisilluminatedinred,thepre-
ampisclipping.ToreduceclippingturndowntheVOLUME.*
1
7.VOLUME:Controlsthepre-amplifierlevel.*
1
8. 3 BAND EQ: Refer to the spec sheet at the end of this manual for
frequencies and levels.
9. CHORUS: Controls the speed of the chorus effect. Turn this con-
troltotherighttoincreasethespeed.Thisfunctionwillbeoffat“0”
position.*
1
10.REVERB:Controlsthereverblevel.Thisfunctionwillbeoffat“0”
position.*
1
11.NOTCHFILTER:Thisisanotchfilterthatreducesfeedback.Turn
thiscontroluntilfeedbackstops.Thisfunctionwillbeoffat“0”posi-
tion.*
2
12. MASTER: Controls the output level from this amplifier. Doesn’t
workforLINEOUTandAUXINsignal.
13.PHASEINVERT:Invertsthephaseofsignal.Thishelpsyoustop
feedback.*
2
14. MUTE: Mutes the signal from MIC INPUT and INST. INPUT., and
theLEDlights.Doesn’tworkforLINEOUTandAUXINsignal.
15. PHONES: 3.5mm stereo mini output jack for stereo headphones.
The sound is not reproduced through the built-in speaker when
headphonesareinuse.Meanwhile,LINEOUTsignalstilloutputs.
Warning:
This phones output produces a large volume of sound. Ensure that
the MASTER and AUX VOLUME has been turned down before
beginning to play using the headphones, and then slowly increase
the volume until it has reached the desired level. Note that the
noise and distorted sound signals produced when inserting or re-
moving the headphone plug at high volume levels will result in
damage to the headphones and to the user’s hearing.
16. AUX IN: 3.5mm stereo mini jack. This jack is designed to be con-
nected to the headphone output of a portable CD or MP3 player, or
similar device. Use the volume control of your portable player along
with the volume control on the amp to adjust the desired volume.
17.AUXVOLUME:ControlsthesignallevelofAUXIN.
18.LINEOUT:Monaural1/4”phonejackwithalineleveloutput.You
can connect to an external mixing console or similar equipment.
REVERBandCHORUSsignalareoutputinstereo.
19. FOOTSWITCH INPUT: Connect the provided footswitch.
20. FOOTSWITCH FUNCTION SWITCH: Switches the footswitch
function that has 2 modes, EFFECT CONTROL MODE and
NOTCHFILTERMODE.Referto“UsingFootswitch”.
21.TILTUPBAR:Thebuilt-intiltsystemallowsforbettermonitoring.
*
1
: The function works in each channel independently.
*
2
: The function might not work perfectly under bad conditions of use.
Rear Panel
A.ACINLET:ConnecttheincludedACpowercabletothisconnector.
Only use this amp with the voltage indicated on the panel.
B. POWER SWITCH: This switch turns the power on/off. When you
are not using the amp, please leave it turned off.