Iclebo Arte YCR-M05 User Manual - ●
8
1. After turning over the vacuum cleaning robot,
verify the positions of the left and right side brushes.
2. Match L side brush to L marked part in the direction
of the groove, and push in hard.
3. Match R side brush to R marked part in the direction
of the groove, and push in hard.
1
2
Mop plate
There is no battery inside the remote controller at the time of purchase.
Install 2 x AAA batteries before using it.
1. Push the cover of the backside of the remote controller downward to open.
2. Check (+)(-) of the battery and assemble.
3. Match the cover to the groove, and close until “click” sounds.
1. Turn over the vacuum cleaning robot, and install the mop plate by combining it to the fixing part of the main body.
2. If mopping mode is not used, separate and keep the mop plate saperate from the main body.
※ In Mopping mode with mop plate attached, there may be cases that it is blocked by carpet, rug, or doorsill, and
cannot go forward normally, so be careful. In such cases, moving the rug or carpet to one side and using Mopping
mode is recommended.
※ In some floor environments, there may be cases of not being able to go forward normally. If it cannot go forward
normally in the floor environment of marble floor or certain patterns, then also set Climb mode for cleaning.
Ultra microfiber mop
●
Installing the r
obot c
leaner
Check list before using
Assemble side-brush
Insert remote control battery
Assemble ultra microfiber mop