Icom IC-F14 Instruction Manual - page 9
10
2
PANEL DESCRIPTION
11
2
PANEL DESCRIPTION
2
MONITOR KEY
➥
Mute and release the CTCSS (DTCS) or 2-tone squelch mute.
Open any squelch/deactivate any mute while pushing this key.
(LMR operation only)
➥
Activates one of (or two of) the following functions on each chan-
nel independently: (PMR operation only)
• Push and hold to un-mute the channel (audio is emitted; ‘Audible’
condition).
• Push to mute the channel (sets to ‘Inaudible’ only).
• Push to un-mute the channel (sets to ‘Audible’ only).
• Push after the communication is finished to send a ‘reset code’.
NOTE:
The un-mute condition (‘Audible’ condition) may auto-
matically return to the mute condition (‘Inaudible‘ condition)
after a specified period.
LOCK KEY
Push and hold to electronically lock all programmable keys except
the following:
[Call]
(incl. Call A and Call B),
[Moni(Audi)]
and
[Emergency]
keys.
OUTPUT POWER SELECTION KEY
Select the transmit output power temporarily or permanently, de-
pending on the pre-setting.
• Ask your dealer for the output power level for each selection.
TALK AROUND KEY
➥
Push to turn the talk around function OFF.
➥
Push and hold to turn the talk around function ON.
• The talk around function equalizes the transmit frequency to the re-
ceive frequency for transceiver-to-transceiver communication.
WIDE/NARROW KEY
➥
Push to select the IF bandwidth to wide.
• The wide passband width can be selected from 25.0 or 20.0 kHz
using the CS-F14
CLONING SOFTWARE
. (PMR operation only) Ask
your dealer for details.
➥
Push and hold to select the IF bandwidth to narrow.
DTMF AUTODIAL KEY
Push to transmit the programmed DTMF code.
CALL KEYS
Push to transmit a 2/5-tone code.
• Call transmission is necessary before you call another station de-
pending on your signalling system.
•
[Call A]
and/or
[Call B]
keys may be available when your system em-
ploys selective ‘Individual/Group’ calls. Ask your dealer which call is
assigned to each key.
EMERGENCY KEYS
➥
Push and hold to transmit an emergency call.
➥
When
[Emergency Single (Silent)]
or
[Emergency Repeat
(Silent)]
is pushed, an emergency call is transmitted without a
beep emission.
• If you want to cancel the emergency call, push (or push and hold)
the key again before transmitting the call.
• The emergency call is transmitted one time only or repeatedly until
receiving a control code depending on the pre-setting.
VOICE SCRAMBLER FUNCTION KEYS
➥
Push to turn the voice scrambler function OFF.
➥
Push and hold to turn the voice scrambler function ON.
OPT OUT KEYS
➥
Push to inactivate the connected output signal level.
➥
Push and hold to activate the connected output signal level.
SIREN KEY
Push to emit a siren. This function can be used for situations other
than an emergency alert such as a security alarm for example.
IC-F14_F24-2.qxd 04.7.22 0:57 PM Page 10 (1,1)