Icom IC-F510 Instruction Manual - page 9
6
1
PANEL DESCRIPTION
EMERGENCY KEY
Push and hold to transmit an emergency call.
• If you want to cancel the emergency call, push (or
push and hold) the key again before transmitting the
call.
• The emergency call is transmitted one time only or
repeatedly until receiving a control code depending
on the pre-setting.
TX CODE ENTER KEY
(p. 10)
Push to directly enter the TX code edit mode.
Then, set the desired digit using
[
]
or
[
]
.
TX CODE CH SELECT KEY
(p. 10)
➥
Push to enter the TX code channel selection
mode. Then, select the desired channel us-
ing
[
]
or
[
]
.
➥
Push and hold this key for 1 sec. to enter the
TX code edit mode. Then, set the desired
digit using
[
]
or
[
]
.
TX CODE CH UP/DOWN KEYS
(p. 10)
Push to select a TX code channel directory.
ID-MR SELECT KEY
➥
Recalls detected ID codes.
• Push this key, then select the ID code using
[
]
or
[
]
.
• Up to 5 ID’s are memorized.
➥
Push and hold this key to erase all memo-
rized IDs.
SCRAMBLER KEY
➥
Push and hold to turn the voice scrambler
function ON.
➥
Push to turn the voice scrambler function
OFF.
NOTE:
• Optional UT-109 (#02) or UT-110 (#02)
VOICE SCRAMBLER UNIT is required.
- UT-109: Non-rolling type.
32 codes are available.
- UT-110: Rolling type. Provides higher
communication security.
1020 (4 groups
×
255) cods are
available.
• This transceiver requires version #02 unit,
do not install version #01, as they are not
compatible.
• UT-109 and UT-110 require some PC board
modifications. Please refer ‘
n
Optional UT-
109/UT-110 installation’. (p. 17)
• Please contact your Dealer for details.
[EMER]
[CODE]
[TX CH]
[CH UP]
[CH DN]
[ID MR]
[SCRM]