Icom IC-F521 Instruction Manual - Turning Power On
■
Turning power ON
q
Push [POWER] to turn the power ON.
• A power-up alert tone sounds for about 1 sec. and an openng
message may appear.
w
If the transcever s programmed for a start up passcode,
nput dgt codes as drected by your Dealer.
• The keys n the table below can be used for password nput:
• The transcever detects numbers n the same block as dentcal.
Therefore “01234” and “56789” are the same.
KEY
[P0]
[P1]
[P2]
[P3]
[P4]
NUMBER
0
1
2
3
4
5
6
7
8
9
e
When the “PASSWORD” ndcaton does not clear after
nputtng 4 dgts, the nput code number may be ncorrect.
Turn power off and start over n ths case.
■
Channel selection
Several types channel selectons are avalable, methods
may dffer accordng to your system set up.
NON-BANK TYPE:
Push
[CH UP]/[CH DN] to select the desred operatng
channel, n sequence; or, push one of the
[
CH 1
] to [CH 4] to
select a channel drectly.
BANK-TYPE:
Push
[BANK] to select the desred bank number.
AUTOMATIC SCAN TYPE:
Channel settng s not necessary for ths type. When turnng
the power ON, the transcever automatcally starts scannng.
Scannng stops when recevng a call or when takng the
mcrophone off hook.
7
2