Ipcr1000 instruction manual communications receiver for computer this device complies with part 15 of the fcc rules. Operation is sub- ject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interf...
I important read all instructions and on-line help care- fully and completely before using the receiver. Save this instruction manual — this instruction manual contains important operating instructions for the ic-pcr1000 communications receiver for computer. Use antenna(s), such as a well-matched 50...
Ii cautions r warning! Never connect the receiver to an ac outlet. This may pose a fire hazard or result in an electric shock. Never connect other than the specified ac adapter to the receiver. This connection will ruin the receiver. Never connect the receiver to a power source of more than 16 v dc ...
Installation 1 1 ■ hardware installation refer to the diagram below for connections. Co mm un ic at io ns r ec ei ve r ic - pc r1 00 0 ground remove the protective sheet and attach to a specified place. To an ac adapter to an rs-232c port optional speaker (sp-7, sp-10, sp-12) personal computer.
1 installation 2 ■ antenna installation antennas play a very important role in receiver operation. Connecting a poor quality antenna to the ic-pcr1000 will re- sult in less than optimum performance. Select antenna(s), such as a well-matched 50 Ω antenna and feedline. 1.5:1 of voltage standing wave r...
1 installation 3 ■ af output level selection the received audio can be input into your computer via the sound card. Before inputting the received audio into the [line in] con- nector (connector name depends on your sound card), the output level of the [ext-sp] must be set properly. Perform as follow...
1 installation 4 ■ tnc connection the ic-pcr1000 can receive 9600 bps packet communica- tion (afsk). Connect the tnc (terminal node controller) as follows. Co mm un ic at io ns r ec ei ve r ic -p cr 10 00 tnc personal computer ic-pcr1000 to [packet].
1 installation 5 ■ software installation note: before using the program, make a backup copy of the original disk. After making a backup copy, keep the original disk in a safe place. D windows 95 q boot up windows. - quit all applications when windows is running. W insert the backup disk 1 into the a...
Panel description 2 6 ■ component screen see the on-line help for more information. Q bank (memory bank) button used to change the memory bank number indication and memory bank name indication when using the component screen. W bank (memory bank) indicator indicates the memory bank (and its name if ...
2 panel description 7 !3 busy indicator appears when receiving a signal or when signal noise opens the squelch. !4 signal meter indicates the receive signal strength. Also indicates the s- meter squelch receive level set via the [squelch] scroll bar. !5 center indicators indicate the tuning level wh...
2 panel description 8 @3 delay time scroll bar this sets the period in which a scan pauses after receiving a signal. Moving the knob to the right increases the period; to the left decreases the period. @4 speed (scan speed) scroll bar sets the speed at which scans search through frequen- cies/memori...
2 9 panel description #9 +200k/–200k (max. Frequency span value) indicators indicate the upper and lower observable frequency limits around a receive frequency. In the diagram, the upper and lower limits are +200 khz and –200 khz. $0 center frequency indicator indicates the center frequency of the f...
2 10 panel description ■ radio screen the radio screen shows 10 memory channel buttons and fre- quency readout, etc. Like a typical stereo tuner—this provides the simplest operation for monitoring your most-listened-to- stations, such as am/fm broadcasting and tv, etc. See the on-line help for the r...
Specifications and unpacking 3 11 • frequency coverage (mhz): u.S.A. 00 0.010000–823.999999* 849.000001–868.999999 894.000001–1300.000000 europe 00 0.010000–1300.000000* * specifications guaranteed 0.5–1300 mhz only. • receive system : triple superheterodyne • mode : wfm, fm, am, ssb, cw • frequency...
3 specifications and unpacking 12 ■ unpacking q telescoping antenna ....................................................... 1 w rs-232c cable (opc-743) ............................................. 1 e external speaker plug ..................................................... 1 r ac adapter (bc-123...
A-5456g-1ex- w printed in japan © 1997 icom inc. 6-9-16 kamihigashi, hirano-ku, osaka 547-0002 japan.
