Interserve 80 late-breaking news november 1998 dha025360
Copyright 1998 intergraph computer systems. All rights reserved. This document contains information protected by copyright, trade secret, and trademark law. This document may not, in whole or in part, be reproduced in any form or by any means, or be used to make any derivative work, without written ...
1 general system graphics the system reference refers to specific graphics cards. However, your system may have been delivered with graphics not referred to in the system reference. See the separate graphics documentation delivered with the system for information on your system’s graphics. Three-but...
2 megaraid controller and software information for information on the ami megaraid controller installed in an interserve 80 with internal raid, and for information on the megaraid software, refer to the interraid-8e documentation delivered with the system. On a server with an interraid disk array, y...
3 u the bios setup options floppy access control and ide hard disk access control (used to write-protect these devices) have no effect under windows nt. Windows nt does not use the bios for peripheral device access. U immediately after installing a symbios scsi adapter card, you must run the symbios...
4 option notes min, 3 min., 4 min., 5 min., 6 min, 7 min., 8 min., 9 min., 10 min., 11 min., 12 min., 13 min., 14 min, and 15 min. The optimal and fail-safe settings are disabled. Standby time out this option specifies the length of a period of system inactivity while in the full on power state. Whe...
5 document errata in the system setup document: u in chapter 2, “setting up the software,” the location of the online system introduction document may be incorrect. The correct location is c :\ win 32 app \ sysintro . U in chapter 4, “operating notes,” the locations of the system’s serial number and...
6 2. When prompted, press s to specify a mass storage device other than those listed. 3. When prompted, select other from the list of devices presented. 4. Follow the prompts to install the driver from the 2940 scsidrv backup diskette. When presented with a list of adaptec scsi controllers, select t...
