J&M Corporation ROKKER JAMP-630HC06-SGP Installation and operation instructions - page 2
Product Description
This new J&M ROKKER XXRP DSP controlled 4-channel 630
watt RMS fairing/rear speaker amplifier kit has been designed
specifically for use on the 2006-2013 Harley® StreetGlide (NOT
for 2011-2013 CVO) with the stock Harley HK radio with rear-lid
or lower-fairing speakers added.
The specific plug-n-play RCA input harnesses included with this
amplifier kit, take the 2-channels of audio signal available from
the StreetGlide version of the Harley HK radio and provides
4 separate channels of amplification at 157.5 watts RMS
continuous power per-channel into a 2 or 4-ohm speaker load.
(Manually selectable on the amplifier itself for a 2-ohm or
4-ohm speaker load)
This is a full range class D digital amplifier properly shielded
against RF interference into the AM or FM stereo radio bands.
The ROKKER XXRP amplifier uses advanced digital switching
power supply technology to dramatically reduce the 12v current
demands on the motorcycle electrical system, compared to
other brand amplifiers in this power range.
Amplifier mounts to the custom made stainless steel 2-piece
bracket system, to provide solid and secure mounting inside the
StreetGlide or Ultra fairing, in addition to blocking amplifier heat
from being transferred to the radio.
These new ROKKER XXRP series amplifiers are fully
programmable thru the internal digital signal processor (DSP)
and come out of the box already dialed in for this specific
StreetGlide custom speaker configuration, to provide maximum
highway performance from your Harley Davidson audio system.
Should you wish to alter these DSP settings using the internal
programming dongle already built into this new amplifier, (USB
computer connection cable also included with this amplifier kit)
Also included are our custom made heavy-gauge power and
ground wires used for the fused battery & frame connections,
along with all necessary mounting hardware & complete
installation/operation instructions.
Amplifier itself measures 8 1/4” Long X 5 1/8” Wide X 1 5/8”
Tall.
Installation Instructions
1. Remove the outer fairing shell, seat, and fuel tank.
2. By following along the factory wiring harness, route the
amplifier power harness from the fairing, under the fuel tank,
and on to the battery. (removal of the fuel tank is necessary for
proper installation)
3. After first disconnecting the negative battery cable from
the battery, connect the positive (red) lead from the amplifier
power harness directly to the positive post of the battery. Then
connect the negative (black) lead from the power harness to
the same bolt/stud on the frame that the negative battery cable
is connected to. Then reconnect the negative battery cable to
the battery. (Figure A) Do not connect the negative (black) lead
from the amplifier to the negative post of the battery.
4. For models with a CB and/or a SAT Radio installed,
disconnect and remove them from the top of the factory radio.
(Figure B)
Replace the factory retention screws back into the
radio. For models without a CB or SAT Radio, continue with the
next step.
5. Remove both the left and right forward radio mounting
bolts. Loosen but do not remove both the left and right
rearward mounting bolts. (Figure C)
BATT
+
Black
Red
Master Frame
Grounding Stud
Negative
Battery Cable
Fuse
Heavy Gauge
Amplifier Power/Ground
Wire Harness
Fig. A