J&M Corporation ROKKER JAMP-630HC06-SGP Installation and operation instructions - page 5
Fig. H
ROKKER® XXRP 630
Full Range Class D Amplifier
Output Power (RMS) @ 1% THD 1000Hz 14.4V CEA 2006
Stereo @ 4ohms
4 x 157.5 Watts – 630w RMS Total
Stereo @ 2ohms
4 x 157.5 Watts – 630w RMS Total
Frequency Response -3dB
1Hz - 69kHz Capable
S/NRatio
Separation
>90dB
>74dB
Input Sensitivity
.35V - 3.9V
Input Impedance
47.5K
Specifications
Fig. G
FOR MODELS WITH A CB AND/OR SAT RADIO, CONTINUE
WITH STEPS (11) THRU (13), FOR BIKES WITHOUT A CB OR
SAT RADIO, PROCEED TO STEP (14).
11. Install the previously removed CB and/or SAT Radio
modules into the J&M lower mounting bracket and secure using
the (2) 8-32x1/4 screws provided. (these are the longer of the
remaining screws) (Figure G)
12. Position the lower bracket assembly below the factory radio
and secure using the (4) remaining 8-32x3/16 screws provided.
(Figure H)
(Remove and re-secure any factory wiring attached
to the bottom of the radio using the tie-straps provided)
13. Re-connect the CB and/or SAT Radio harness and antenna
connectors.
14. Test the system for proper operation before reassembling
the fairing, realizing that full sound quality and fidelity will not
be heard until the outer fairing shell is completely reinstalled.