J&M Corporation ROKKER JAMP-630HC06-SGP Installation and operation instructions - page 3
of
5
Move outside fairing brace
Remove
Fig. D
6. Relocate the large plugs from
the inside of the fairing braces
to the outside of the the fairing
braces. (Figure D)
7. Remove the (4) rubber
grommets from the top of the
factory radio. (Figure D)
Fig. E
8. Position the J&M Amp/Bracket assembly above the radio
and slide into position. (Remove tie-straps and re-position the
factory wiring harness as needed to allow the amplifier to fit
into place properly)
9. Replace the forward radio mounting bolts and then tighten
all (4) of the mounting bolts. (Figure E)
10. Make Amplifier/Speaker connections according to diagram.
(Figure F)
Fig. B
remove
remove
loosen
Fig. C