JabloCom JabloPhone GDP-04i User Manual - page 16
XC_GDP-04i.ENG.MAN.Manual.15.A
- 14 -
EN
U
se
r‘
s
G
u
id
e
Choose
Menu > Settings > Remote controls >
Voice message
for recording a new voice message.
Call to the GDP-04i RF from another phone. GDP-04i RF
receives the call automati cally. Aft er 4 beeps it starts
recording. The voice message could be
up to 15 seconds long. If you want a shorter message
press
Stop
. The phone than replays the message back.
Press
Save
for saving the voice message.
If you like to check the recorded message, go to the
menu
Voice message
and press
Play
.
Aft er pressing the panic butt on or acti vati ng the sensor, the emergency messages are sent fi rst. Then phone
calls to the fi rst phone number. When the call is connected, phone plays the voice message twice and than
connects audio to the hands free. When the call is fi nished, the phone calls to all other numbers in the same
way. The length of the call is limited to 5 minutes.
If you press a panic butt on during a ringing incoming call, the phone receives the call to the hands free mode.
Try
the emergency functi on aft er completi ng setti
ngs.
Pressing the panic butt on during incoming call accepts the call on the handsfree. Phone can be operated by
one wireless butt on both way (making calls, receiving calls).
A wireless relay can be operated via SMS sent to GDP-04i RF or from the phone’s menu. All setti ngs are done in the
Menu > Settings > Wireless relay
menu.
If you enter the
Menu > Settings > Wireless relay
menu for the fi rst ti me, the phone guides you
thru all necessary setti ngs.
To enroll GDP-04i RF into a new wireless relay (for example AC-88) switch the relay into the enrollment mode and
choose
Enroll new relay
on the phone. The phone sends the enrollment signal immediately.
For changing the output name go to the menu
Menu > Settings >
Wireless relay > Settings .
Use right arrow or green butt on to
change it.
Use
Mode
for switching between
On/Of f
and
Pulse
. If the output is in the
On/Of f
mode, it reacts to the SMS message accordingly. If it is in the
Pulse
mode, it switches on only for 2 seconds.
For operati ng the outputs send an SMS to the GDP-04i RF phone number.
Syntax of the SMS is:
where:
is
ON
for switching on the output,
OFF
for switching the output off .
This text cannot be changed and depends on the selected language.
is
DEVICEX
or
DEVICEY
as a default. User can modify the output name.
If you like to switch the output on for the limited ti me, send an SMS
Examples:
ON deviceX
Switches on permanently the output PgX of the wireless relay
OFF DEVICEY
Switches off permanently the output PgY of the wireless relay
ON DEVICEX 3:00:00
Switches on for 3 hours the output PgX of the wireless relay