Jabra FREEWAY User Manual - English
14
ENGLISH
JABRA FREEWAY
I cannot use Reject call, call on hold, Redial or voice dialing
- These features are dependent on the ability of your phone to
support a hands-free profile . Even if the handsfree profile is
implemented reject call, call hold and voice dialing are optional
features which are not supported by all devices . Please consult
your device manual for details .
Please note that some features can only be operated from the
primary device e .g . voice dial using Jabra FREEWAY with 2 mobile
phones .
I can not connect speakerphone and radio via FM transmitter
- Make sure the radio is turned on and speakerphone is in FM
mode (FM Status Icon is on) .
- If your radio when searching is not able to find the FM frequency
set by your speakerphone, the FM frequency must be tuned
in manually on the radio . Please read radio manual to find out
how to manually change frequency on your radio .
- If your radio is in TA (Traffic Announcement) mode, switch TA
off and your radio should be able to find your speakerphone
when using the search function on the radio . If not tune in
manually .
- The sensitivity of the search function on your radio determines
whether it is able to find the frequency set by your speakerphone .
On some radios you are able to adjust the sensitivity thus
making it possible to find the speakerphone frequency when
searching . If not tune in manually .
- In urban areas it might be difficult to find a clear frequency .
It is therefore advisable to use a frequency in the lower or upper
end of the FM frequency band (e .g . 88 .1 or 107 .7 MHz) where
you will have the best chance to find a clear frequency .
My Jabra FREEWAY does not announce the caller names
during incoming calls
- Ensure that your phone supports the Bluetooth® phonebook
access profile (PBAP) and that the name of the caller is in you
phonebook .
Please note that on some Android phones a warning message
about the phonebook transfer appears in the top left corner . You
must select this message and agree to the connection in order to
get caller ID to function properly .