Jacobsen HR-9016 Turbo Dealer's Manual - Caution
3 SET-UP
11
3.4 FRONT
DECK _____________________________________________________________
1.
Place braces under left winglet and remove shipping
band. Remove braces and lower winglet to normal
position. Repeat for right winglet.
2.
Assemble rear winglet supports (E and F) to center
deck using 3/8-16 x 1” screws, lockwashers, and
locknuts (G).
3.
Lift front deck to service position [Section 4.3].
Assemble front winglet supports (H) to winglets
using 3/8-16 x 1” screws, lockwashers, and flat
washers (J). Lower front deck.
4.
Remove Caution tag from steering column and
center lift control lever.
Figure 3B
Figure 3C
3.5
FRONT LIFT LIMIT SWITCH _________________________________________________
Note: For safety and shipping purposes, the front deck
motors have been disabled. The front deck motors will
not operate until the front lift limit switch is reconnected.
1.
Remove four 3/8-16 x 7/8” truss head screws (K) and
lift floorboard (L) from tractor.
2.
Locate and connect front lift limit switch connector
(M).
3.
Assemble floorboard (L) using screws (K).
Figure 3D
CAUTION
To prevent personal injury or damage to the
equipment, do not attemp to raise or lower front deck
with shipping bands installed. Place braces under
deck winglets before cutting shipping bands. Slowly
and carefully lower winglets to normal operating
position. Do Not allow winglets to drop from shipping
position onto front deck.
!
E
F
G
G
H
H
J
J
M
L
K