Jade CONVECTION OVEN Installation, Operation And Maintenance Instructions - page 18
P/N 24-156 REV A 7/00
Page 18
diagram
To Program
Press “START/STOP” button until display alternates between
“STOP” and “SENSE” temperature. The control is now ready
for programming.
PREHEAT TEMP
Press “PROG ADV” button until “PREHEAT TEMP” light turns
on. Press ↑ or ↓ buttons to obtain desired temp. If preheat
cycle is not required, press ↑ or ↓ buttons until “OFF” is
displayed.
COOK TEMP
Press “PRG ADV” button until “COOK TIME” light turns on.
Press ↑ or ↓ buttons to obtain desired cook temperature.
COOK TEMP
Press “PRG ADV” button until “COOK TEMP” light turns on.
Press ↑ or ↓ buttons to obtain desired time is displayed. To
disable the cook timer, press ↑ or ↓ buttons until “OFF” is
displayed.
HOLD TEMP
Press “PRG ADV” button until “HOLD TEMP” light turns on.
Press ↑ or ↓ buttons to obtain desired time is displayed. The
hold function can be displayed by pressing ↑ or ↓ buttons until
“OFF” is displayed.
Press “PRG ADV” button again returns control to “stop mode.”
The display will alternate between “STOP” and probe sense
temperatures. The control is now ready for cooking.
To Cook
1.
Press “Start/Stop” button. The “CYCLE ON” light will turn
on, the fan will be activated, and the controller will
regulate the oven to the pre-heat temperature. The
display will alternate between “PrE” and probe temp.
2.
When the oven temp reaches the desired pre-heat temp,
the control will enter a pause mode with the “CYCLE ON”
light flashing and a 5-second pulsing audio alert will be
activated. The control will maintain the oven temp until
product is loaded into oven and “START/STOP” switch is
pushed.
3.
The control will now regulate the oven to the desired cook
temp and the cook timer will count down. The “CYCLE
ON” light will be on and the display will alternately show
oven temp and cook time remaining.
4.
When cook time reaches zero, the control will regulate
temp to the desired hold temp and a count up timer is
initiated to track the length of time in the hold mode. The
display will alternately show “HOLD” actual oven temp
and hold elapse time. The control will stay in the hold
mode until product is removed and the “START/STOP”
button is pressed.
Reviewing Set Points
During the cooking cycle any programmed cooking parameter
can be ???. Press the “PROG ADV” button until the desired
parameter light turns on. The display will show the value of
the set point for 5 sec. Reviewing set points of cooking cycle
will not alter them or interrupt the cooking cycle.
Changing the Set Points During Cooking
Push “START/STOP.” Momentarily the “CYCLE ON” light will
flash and control will go into pause. In this mode, the control