Jade CONVECTION OVEN Installation, Operation And Maintenance Instructions - page 19
P/N 24-156 REV A 7/00
Page 19
regulates the pre-set points, but the cook count down timer will
stop. Pressing the “PROG ADV” button until the desired
indicator light turns on can change cooking parameters. The
display will show preset value. Pressing the ↑ or ↓ will allow
settings changed as desired. To reuse cooking cycle, press
“START/STOP” button. The “CYCLE ON” light will come on
and cooking cycle will resume.
To Cancel Cooking Cycle
Depress the “START/STOP” button and hold until “CYCLE ON”
light turns off.
Power Failure During Cooking Cycle
The control will suspend operation, retaining set points and
cycle times. When power is restored, operation will resume
where left off when power failed.
Fan Operating Logic
On Models OC100 &OC102 fan is on continuously during cook
mode and only when heater output is on during hold mode.
On Models OC101 & OC103 fan is on continuously during cook
and hold modes.
C Operation
Removal of an internal jumper wire “J” converts control to “C”
operation.
Probe Diagnostics
If the probe fails open electrically, the control will cancel the
cooking cycle the display will show “PROB”.
If probe temp goes below 50°F or if the control fails, the display
will show ”EEEE” and control will go into “STOP” mode.
DIAGRAM
•
TENSION OF MECHANISM:
Make adjustments by alternate turning of turnbuckles,
until the doors are properly synchronized.*
When finished, tighten the turnbuckle lock nuts.
ADJUSTMENTS:
WARNING:
ALL SERVICE WORK ON THIS APPLIANC
BY A QUALIFIED TECHNICIAN WHO IS EXPERIENCED AND
KNOWLEDGEABLE WITH THE COMMERCIAL GAS COOKING
EQUIPMENT. CONTACT YOUR AUTHORIZED DEALER
AGENCY FOR RELIABLE SERVICE, DEPENDABLE ADVICE AND
GENUINE FACTORY PARTS.
CAUTION
HEAT
ZONE