Jcb AG2200 Safety And Operating Manual - Auto-Stop Carbon
SO53 3LE
Customer Helpline 0845 600 5526
guard for cutting.
When cutting, do not press, tilt or
oscillate the machine. Work with
moderate feed, adapted to the
material being cut.
Do not reduce the speed of running
down cutting discs by applying
sideward pressure.
The direction in which the cutting is
performed is important.
The cutting disc must always
be used in an upward motion.
NEVER move the cutting disc in
other directions otherwise it may
be pushed out of the cut in an
uncontrolled way.
AutO-stOP CARBON
BRusHEs
After prolonged use the carbon
brushes will wear. This machine
is fitted with Auto Stop Carbon
Brushes that will automatically shut
down the motor when the brushes
become worn.
When this occurs, both carbon
brushes should be replaced. Keep
the carbon brushes clean and free
to slip in the holders. Both carbon
brushes should be replaced at
the same time. Use only identical
carbon brushes. (See 7 )
7
16
14
15