Jeep grand cherokee 2018 Quick Reference Manual - page 15
Wiper/Washer Controls
The multifunction lever is located on the left
side of the steering column.
Front Wiper Operation
The front wipers are operated by rotating a
switch, located on the end of the lever.
Rear Wiper Operation
The rear wiper/washer is operated by rotating a
switch, located on the middle of the lever.
Rain Sensing Wipers
This feature senses moisture on the windshield
and automatically activates the wipers for the
driver. The feature is especially useful for road
splash or overspray from the windshield wash-
ers of the vehicle ahead. Rotate the end of the
multifunction lever to one of four settings to
activate this feature.
For further information, and applicable warn-
ings and cautions, please refer to the Owner’s
Manual
at
www.mopar.com/en-us/care/
owners-manual.html
(U.S.
Residents)
or
www.owners.mopar.ca (Canadian Residents).
Automatic High Beam — If
Equipped
This system automatically controls the opera-
tion of the headlamp high beams as oncoming
vehicles approach.
• The Automatic High Beam Headlamp Con-
trol can be turned on or off using the
Uconnect System.
• Push the turn signal lever away from you.
• With the headlight switch in the “AUTO”
position, the high beams are controlled
automatically.
• Pull the turn signal lever toward you to
manually deactivate the system.
• To improve system recognition of crossing
traffic, and to limit use in a residential area,
the vehicle must be moving at a speed
greater than 20 mph (32 km/h) before the
Automatic High Beam Module (AHBM) be-
gins requesting high beam activation.
NOTE:
If the windshield or Automatic High Beam
Headlamp Control mirror is replaced, the mirror
must be re-aimed to ensure proper perfor-
mance. See a local authorized dealer.
Multifunction Lever
WINDSHIELD WIPER/WASHER
FEATURES
LIGHTS