Jenaer ecolin 200 Installation Manual - page 2
Jenaer Antriebstechnik GmbH
ECOSTEP
200
S2 (13)
Safety Instructions / Technical Specifications / Installation, Date 09/2007
Safety Instructions
General
•
All transportation, storage, assembly, installation, connection, comissioning and service
work must only be carried out by qualified skilled personnel taking the following into
account the relevant documentation, regulations and requirements pertaining to the
equipment concerned as well as national and regional safety and accident prevention
regulations.
Qualified skilled personnel are persons who have a relevant vocational qualification and
have proper knowledge of the execution of the above-mentioned work.
•
Read the documentation carefully before installation and comissioning. Serious injury
to persons and equipment may result through improper use of the device or incorrect
installation or operation. All technical specifications and conditions must be adhered to
in all cases.
•
The device contains electrostatic sensitive components, which may be damaged by
improper handling. Discharge yourself before you touch the device. Avoid contact to
high isolating materials (e.g. synthetic fibres, plastic films, etc.).
•
Control and power connectors may be energized even when the motor does not move.
•
All electrical connectors of the device must not be neither plugged in nor disconnected
under voltage since electric arcs may demage persons and connectors.
•
Do not touch components which are energized during operation immediately after dis-
connection from supply. Wait after disconnection of the device from the power supply at
least 6 minutes before you touch components which are energized during operation.
The DC-Bus capacitor remains charged to dangerous voltages up to 6 minutes after
power-off. This time could be higher depending on the external power supply. For your
safety, measure the DC-Bus voltage and wait until it is lower than 40V.
Proper Use
The device ECOSTEP is intended for use in commercial equipment and comply with the
aplicable standards and regulations and meets the requirements of the Low Voltage
Directive 73/23/EEC. All technical specifications and permissible conditions mentioned in
the documentation must be adhered to in all cases. The device ECOSTEP is a component
intended for installation in machinery. Comissioning (starting operation in accordance with
the intended use) is prohibited until such time as the machine’s conformity with EMC
Directive 89/336/EEC and Machinery Directive 89/392/EEC has been established (note
EN 60204).
The following are prohibited, unless expressly provided otherwise:
•
use in hazardous areas
•
use near oils, acids, gases, vapours, dust, radiation, etc.