Jenn-Air 30" (76.2 CM) Installation Instructions Manual - Installation Instructions
8
Make sure that the electrical connection and wire size are
adequate and in conformance with the National Electrical Code,
ANSI/NFPA 70-latest edition or CSA Standards C22.1-94,
Canadian Electrical Code, Part 1 and C22.2 No. O-M91-latest
edition, and all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
Before You Make the Electrical Connection:
To properly install your cooktop, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
■
A 4-wire or 3-wire, single phase, 120/240 volt, 60 Hz., AC
only electrical supply is required on a separate, 40-amp
circuit (45" [114.3 cm] models) or 40-amp circuit
(30" [76.2 cm] models), fused on both sides of the line.
■
The cooktop should be connected directly to the junction box
in the cabinet through the flexible metal conduit. The flexible,
armored cable extending from the fuse box or circuit breaker
box should be connected directly to the cooktop wiring box.
■
Locate the junction box in the cabinet to allow as much slack
as possible between the junction box and the cooktop so that
the cooktop can be moved if servicing becomes necessary in
the future.
■
A UL listed or CSA approved conduit connector must be
provided at each end of the power supply cable (at the
cooktop wiring box and at the junction box in the cabinet).
■
If the house has aluminum wiring follow the procedure below:
1. Connect a section of solid copper wire to the pigtail
leads.
2. Connect the aluminum wiring to the added section of
copper wire using special connectors and/or tools
designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's recommended
procedure. Aluminum/copper connection must conform with
local codes and industry accepted wiring practices.
INSTALLATION INSTRUCTIONS
Prepare Cooktop
Decide on the final location for the cooktop.
1. Open product as instructed on product packaging.
2. Remove shipping materials and tape from cooktop.
3. Remove vent grille and grates if present.
4. Remove the removable grease filter by lifting the filter out.
5. Using 2 or more people, remove the cooktop from the carton.
6. Use foam end caps from the packaging as a work surface for
the floor or countertop.
7. Using 2 or more people, place the cooktop on the foam end
caps.
8. Avoid placing the cooktop face down on the control knobs.
9. Turn tie down bolt on each end of cooktop burner box bottom
counter clockwise so the bolt does not protrude beyond the
side wall of the burner box bottom.
A. Vent grille (already removed)
B. Grates
C. Removable grease filter
D. Radiant element cartridge
WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
A
B
C
D