1. DL manuals
  2. Kaba Mas
  3. Locks
  4. 1F
  5. Operating Instructions Manual

Kaba Mas 1F Operating Instructions Manual

Manual is about: HIGH SECURITY ELECTRONIC LOCK

Summary of 1F

  • Page 1

    Operating instructions x-09 tm type 1f high security electronic lock.

  • Page 2: Able

    T able of c ontents i ntroduction ..............................................................................1 lock on back cover ........................................................................ 1 d ialing the x-09 .......................................................................2 d...

  • Page 3: Ntroduction

    1 i ntroduction the x-09 uses sophisticated computer security and makes dialing much easier than that of traditional combination locks. The microprocessor in the lock recognizes a number as part of a combination when you change dialing direction. (see the section on dialing the x-09.) note: the lock...

  • Page 4: Ialing

    2 d ialing the x-09 dialing methods the user should dial with complete, full wrist turns. Stopping to re-grip produces pauses in dialing activity. This helps the x-09 distinguish between human and robotic dialers. Note: the viewing angle of the lcd is restricted from either side as a security featur...

  • Page 5

    3 if you pass your target number when dialing: example a: target number = 25. If you pass your target number by 4 or more, continue dialing until you reach the target number again. Example b: target number = 25. If you pass the target number by no more than 3 numbers, you may continue dialing until ...

  • Page 6: Pen

    4 o pen and c lose the x-09 ( factory combination ) if you have not read the section on “dialing the x-09”, it is important that you do so before proceeding. Note: the lock is shipped preset to operate in the single combination mode with a default factory combination of 50-25-50. To open the lock (u...

  • Page 7: X-09 L

    5 x-09 l ock s etup setting up the x-09 lock for operation involves both the operating mode and the combination(s). Note: the lock is shipped preset to operate in the single combination mode with a factory combination of 50-25-50. Before you can set a new combination, you must select and set a mode ...

  • Page 8

    6 if you have lost or forgotten the combination(s) and are using the serial number method to complete this process, simply dial an incorrect combination to get a lightning bolt display.The error must be created before inserting the change key, and the change key must be inserted while the lightning ...

  • Page 9

    7 note: if the correct combination is not displayed, you may pull out the change key and the lock will allow you to reset the combination. You must pull out the change key while the display is still fl ashing. When ec appears, insert the change key again and dial the desired combination. 11. Pull ou...

  • Page 10

    8 note: in dual combination mode you may dial either combination fi rst to confi rm. In super/sub mode you must dial the supervisory combination fi rst and the subordinate combination second as you did when fi rst entering the combinations. 15. Dial right (cw). After op with a right arrow (open righ...

  • Page 11: Sing

    9 u sing the x-09 if you have not read the section on “dialing the x-09”, it is important that you do so before proceeding. Single combination mode in this mode the x-09 functions much like a standard combination lock. It will open any time the three-number combination is correctly dialed. 1. Dial l...

  • Page 12: Supervisory/subordinate Mode

    10 note: if at any time the dial remains stationary for more than 40 seconds, the computer will reset (lcd will go blank) requiring the operator to redial the entire combination. Supervisory/subordinate mode in this mode, two combinations must be correctly dialed to open the lock. However, it is dif...

  • Page 13

    11 to lock up (lu) supervisory operator: 1. Dial left (ccw) until lock is “powered”. 2. Dial the supervisory combination as if dialing a combination to open the lock; i.E., left (ccw) to dial the fi rst number, right (cw) to dial the second number, left (ccw) to dial the third number. Example: combi...

  • Page 14: Udit

    12 a udit f eatures of the l ock the x-09 lock tracks the number of successful openings for the lifetime of the lock. It also tracks the number of consecutive unsuccessful attempts and will alert you upon lock power up if there have been 3 or more consecutive unsuccessful attempts to open the lock. ...

  • Page 15: Uide

    13 g uide to s ymbols blank display lock is powered down. Op open right lightning bolt incorrect combination dialed. (when this symbol appears in the upper left corner of the display, dial the correct combination.) lightning bolt with error count incorrect combination dialed xx times. (the error cou...

  • Page 16: Otes

    N otes.

  • Page 17

    Document number 520.021 rev. D - 9/08 kaba mas llc 749 w. Short street, lexington, ky 40508 usa phone: 859-253-4744 fax: 859-255-2655 technical support: 800-950-4744 www.Kaba-mas.Com notice: the information in this manual is subject to change without notice and does not represent a commitment on the...