Kaba Mas 1F Operating Instructions Manual - page 9
7
Note: If the correct combination is not displayed, you may pull out the change key
and the lock will allow you to reset the combination. You must pull out the change
key while the display is still fl ashing. When EC appears, insert the change key
again and dial the desired combination.
11. Pull out the Change Key. The Change Key symbol will disappear and CC (Confi rm
Combination) will appear.
12. Dial the new combination once again for confi rmation.
13. Dial right (CW). After OP with a right arrow (OPen right) is displayed, continue dialing
to the right to retract the lock bolt.
The new combination is now set.
If Selection = 02 or 03, Dual Combination or Super/Sub Mode:
In Dual Combination Mode: Either of the two combinations can be entered fi rst and
the combinations may be the same as each other.
In Supervisory/Subordinate Mode: Supervisory Combination must be entered
fi rst, and the Supervisory and Subordinate Combinations cannot be the same
combination.
8. Dial
right (CW)until the symbol C1 (enter Combination 1) appears.
9. Dial the fi rst new combination (Supervisory Combination if operating in Super/Sub
Mode) as if dialing a combination to open the lock; i.e., left (CCW) to dial the fi rst
number, right (CW) to dial the second number, left (CCW) to dial the third number.
EXAMPLE: Set Combination to 30-60-90
Dial left to the fi rst number, 30. Stop.
Dial right to second number, 60. Stop.
Dial left to third number, 90. Stop.
10. Dial right (CW) briskly. The new combination will be displayed two times, two digits at
a time. Once the combination has been displayed, the symbol C2 (Enter Combination
2) will appear.
Note: If the correct combination is not displayed, you may pull out the Change Key
and the lock will allow you to reset the combination. You must pull out the Change
Key while the display is still fl ashing. When C1 appears, insert the Change Key
again and dial the desired combination.
11. Dial the second new combination (Subordinate Combination if operating in Super/
Sub Mode) as if dialing a combination to open the lock; i.e., left (CCW) to dial the fi rst
number, right (CW) to dial the second number, left (CCW) to dial the third number.
EXAMPLE: Set Combination to 25-50-75
Dial left to the fi rst number, 25. Stop.
Dial right to second number, 50. Stop.
Dial left to third number, 75. Stop.
12. Dial right (CW) briskly. The new combination will be displayed two times, two digits
at a time, followed by PO (Pull Out Change Key).
Note: If the correct combination is not displayed, you may pull out the change
key and the lock will allow you to reset the combination. You must pull out
the change key while the display is still fl ashing. When C2 appears, insert the
change key again and dial the desired combination.
13. Pull out the Change Key. The Change Key symbol will disappear and CC (Confi rm
Combination(s)) will appear.
14. Dial the new combinations once again for confi rmation.