Kaffee Konzepte OLC1 Series ‘Lucia’ Users Handbooks - Cleaning The Dispenser
OC Series - Automatic coffee machines
- 5 -
Prime the system with concentrate by pressing and holding the ‘STOP’ button
and then briefly press the ‘Water’ button, release both buttons when you hear
the pump run, the system will then run its priming function automatically
.
When the coffee concentrate runs out, replace the BIB or can and prime as
described above. A sold out system is available as an optional extra.
Cleaning the dispenser
Wipe down the dispenser with a clean damp soft cloth using hot water with a
mild detergent added to remove splash marks etc. Do not use abrasive
cleaning materials, or solvents.
Whenever a BIB is replaced, the cleaning adapter supplied with the dispenser
should be fitted to the suction hose BIB connector and placed in the cleaning
bottle supplied with the dispenser which has been filled with
hot water
above
75°C
from the dispenser and mixed with a suitable food safe sanitising agent
in the correct ratio as stated on the Sanitiser packaging. Press and hold the
‘STOP’ button and also press the ‘Cup’ button until ‘Clean cycle’ is shown in
the display, release both buttons, place a 1 litre water container below both of
the outlet nozzles then press the ‘Water’ button to start the cleaning cycle.
This will run for 15 seconds causing hot water to rinse out both nozzles.
Discard the water collected.
Replace the coffee concentrate and prime as described above.
Power save mode:
To conserve energy and reduce running costs, after approximately half an
hour of non-use the dispenser will switch to ‘Power save mode’ switching off
the boiler and dispenser illumination.
Pressing any button will exit ‘Power save mode’, the display will show ‘Please
wait’ until the machine is again ready to dispense.
Dispenser Set-up mode:
Switch off at the power button on the rear of the dispenser, hold down the
‘STOP’ button while the display shows ‘Please wait’, then release the ‘STOP’
button when ‘Set up’ is displayed. The display will now show the firm and
software versions installed.
Set-up mode enables the selection buttons to be enabled or disabled and
provides the ability to modify a dispense to suit the user.
Press the ‘STOP’ button and the display will change to ‘Press selection’,
pressing the STOP button again will enter ‘Calibrate’ mode, pressing the
‘STOP’ button again will leave ‘Set up’ mode.