Kaffee Konzepte OLC1 Series ‘Lucia’ Users Handbooks - page 6
OC Series - Automatic coffee machines
- 6 -
Changing dispense parameters
1. The display shows:
Press Selection
2. Press the Selection button to be modified.
The display will show (for example):
Cup = Enabled
3. The selection button name is shown and if the selection button is
enabled or disabled.
Press the selection button again to toggle between ‘Enabled’ and
‘Disabled’.
4. Press ‘STOP again to enable or disable preset volume dispensing;
press ‘Cup’ to enable or disable this feature. If ‘Disabled’ is selected
then pressing ‘STOP’ again will jump to ‘Strength setting’. The default
setting is - ‘Enabled’.
5. Press the ‘STOP’ button to step to the dispense size setting.
The display will show (for example):
Size = 38
Press , + or -
Press the ‘CUP’ button (-) to reduce the volume of water dispensed, or
the ‘MUG’ button (+) to increase the volume of water dispensed.
To set a new volume of an unknown amount place the receptacle you
want to fill, for example a cup or a mug or a jug below the nozzle and
then press the ‘JUG’ button. Water will begin to flow from the nozzle
into the receptacle. When sufficient water is in the receptacle, press the
‘JUG’ button again to stop the flow of water.
If the volume of water dispensed is too low or too much, use the ‘CUP’
button (-) to reduce or the ‘MUG’ button (+) to increase the volume of
water dispensed, or press the ‘JUG’ to start again.