Kaffee Konzepte OLC1 Series ‘Lucia’ Users Handbooks - page 9
OC Series - Automatic coffee machines
- 9 -
12. Wait 2 seconds, then press and hold down the ‘STOP’ button and
switch the dispenser back on again.
The display will show
Setup
Press Selection
13. When ‘Press selection’ is displayed press the ‘STOP’ button again.
The display will show
Calibrate?
The display will show
Max temperature
= XX
This sets the normal boiler maximum temperature in degrees Celsius;
use the ‘Water’ button (-) to reduce or the ‘Cup’ button (+) to increase
the water temperature.
14. Press the ‘STOP’ button
The display will show
Calibrate temp
XX°C
Remove the small rubber stopper from the tank top and place a digital
thermometer into the tank through the hole, use the ‘Cup’ button (+)
and the ‘Mug’ button (-) to adjust the water temperature shown on the
display to the actual temperature shown on the Thermometer. Always
replace the rubber stopper in the tank lid when you are finished to stop
steam from the boiler causing problems in the machine.
15. Press the ‘STOP’ button
The display will show
Heat during
Selection = No
Release the Stop button
and the display will change
to:-
Then press the ‘Jug’
button
Pressing the ‘Mug’ button
will enable this function
and ‘Cup’ will disable it.