KAM KSM Vegas LED Instruction Manual - page 4
Remote control pairing
If for some reason the remote control and smoke machine aren’t ‘communicating’ you may need to re-pair the two. Start by turning
the smoke machine off for ten seconds, then turn on the unit, whilst the unit is starting up, press and hold down either button on the
remote control until the LED display on the rear of the unit flashes twice to indicate a pairing. Note: this can take up to 12 seconds.
Manual fog button
After the warm-up process is completed, the LED control display stops flashing. To activate smoke output without using the remote,
press the button located on the rear of the unit. The smoke machine will only output while the button is pressed. Once the button is
released, the fog will stop output.
LED Control display
The built-in control panel on the rear of the machine features four operating buttons and a display which shows the operation status
of the unit. The control panel allows the user to customize the colour of the LEDs, the DMX starting address, wireless remote and the
fluid sensor. The four buttons underneath the LED Control display work as follows:
MENU button: press to scroll through the operating modes
UP button: scroll up through the options
DOWN button: scroll down through the options
ENTER button: confirm a selection
When using either manual or remote control modes, please observe point 10 and do not run the unit for long periods of
time without pausing.
Control menu settings
Display
Function
Addr
Set the DMX address 000 - 512
CoLo
Set the LED colours
rEno
Turns the wireless remote On or Off
OrL
Turns the fluid level sensor On or Off
Colour selections
Pess the button MENU so many times until CoLo is shown in the display. Then press ENTER to select the menu item.
Use the buttons ▲ and ▼ to make your settings. Press ENTER to confirm your settings.
Setting
Function
rand
Random colour change
oFF
LEDs off
Co 1
Red
Co 2
Green
Co 3
Blue
Co 4
Pink
Co 5
Purple
Co 6
Orange
Co 7
Yellow
Co 8
Light blue
Co 9
White
* After setting above colour, the LED will show the corresponding colour when the wireless remote is used. When random colour
change is selected, the LEDs will change their colour when the wireless remote control is used and the interval is 1 second.
* When a DMX controller is used, the colour will be controlled by the controller instead of the manual settings with the control panel.