KAM KSM Vegas LED Instruction Manual - page 5
DMX512 operation
The smoke machine is equipped with 8 control channels. To be able to operate the machine with a DMX controller, the DMX starting
address must be set for the first DMX channel. To achieve this, press the button MENU so many times until “Addr“ is indicated in the
display. Then press ENTER to make your settings. Use the buttons ▲ and ▼ to set the address between 001 and 512. Press
ENTER to confirm your settings. You may now start operating the machine via your DMX controller.
The section below describes all functions of the 8 control channels.
Channel 1 – smoke output
DMX value
Function
000 – 009
Off
010 – 255
On
Channel 2 – brightness red LEDs
DMX value
Function
000 – 009
Off
010 – 255
Dimming from 1 – 100%
Channel 3 – brightness green LEDs
DMX value
Function
000 – 009
Off
010 – 255
Dimming from 1 – 100%
Channel 4 – brightness blue LEDs
DMX value
Function
000 – 009
Off
010 – 255
Dimming from 1 – 100%
Channel 5 – brightness red, green and blue LEDs (colour mixing)
DMX value
Function
000 – 009
Off
010 – 255
Dimming from 1 – 100%
Channel 6 – colour change speed
DMX value
Function
000 – 009
Off
010 – 255
Slow→ fast
Channel 7 – strobe control
DMX value
Function
000 – 009
Off
010 – 255
Slow→ fast
Channel 8 – Master control
DMX value
Function
000 – 009
Off
010 – 255
Dimming from 1 – 100%
Important note regarding the priority level for the three types of methods used to control the operation of your unit.
If using the wireless remote or manual control and then you connect the unit to a DMX controller, the DMX will take priority control.
The priority control levels are:
1. DMX
2. Manual fog button
3. Wireless controller