KAM Laser Tri260 SD FScan Instruction Manual - page 4
of
8
Function mode setting
Master/Slave settings, No DMX Controller
For master/slave mode, put the 2nd switch to ON position and it works as slave.
DMX Control mode
For DMX mode, the 10th dip switch must be ON. Then, set the DMX base address with the binary system
“0” or “1” through switch 1-9
Examples:
DMX address
DMX address
1
33
65
113
161
225
The device has 10 operating channels. If you set the first unit as address “1”, the next DMX device must
start at address 20.
For DMX, switch 10 must be on