KAM Laser Tri260 SD FScan Instruction Manual - page 8
PC MODE
Put the mode switch to PC MODE position and then connect the PC ILDA output interface to the ILDA IN
connector on the rear panel using a standard and easily available (not supplied), ILDA connecting cable. If
you want to make your own cable, you should comply with the below signal definition table of ILDA-DB-
25F pin outs.
Signal name
Pin
Notes
X+
1
-5 to +5V
Y+
2
-5 to +5V
Red+
5
0V to 2.5V
Green+
6
0V to 2.5V
X-
14
Connect to ground
Y-
15
Connect to ground
Red-
18
Connect to ground
Green-
19
Connect to ground
Ground
25
Cable shield
Caution: Because the device is equipped with scanner of 20Kpps, so you should do tune down the setting
of scan rate below 20K per second when you use software (Pangolin, Mamba, Phoenix etc) to control the
device. Too high a scan rate will be greatly harmful to the scanner motor.
IMPORTANT INFO REGARDING SD CARDS
Your Kam SD laser requires the SD card to be formatted in FAT16 to allow files to be recognised. FAT16
(File Allocation Table) is a filing system used in computer memory systems and storage cards.
Required for formatting; SD card reader, SD card and a PC.
Please follow the instructions below to format your SD card in FAT16.
1.
Insert the SD card into the card reader
2.
Right click on the Windows „Start‟ button.
3.
Click once on the „Explore‟ option.
4.
Find the SD card in the Folders section of the window.
5.
Right-click once on the SanDisk (SD) card icon.
6.
Click once on the „Format‟ option.
7.
Change the file system to FAT16 on the “File system” drop-down menu. If your file system options
do
not include FAT16 specifically, use „FAT‟ or „FAT (Default)‟. Both are synonymous with FAT16.
8.
Adjust the „Allocation unit size‟ using the drop-down menu if necessary. The default FAT16
allocation unit size is 16 KB, but you can change it up to 32 KB.
9.
Click once on the „Start‟ button on the Format window after making any desired changes.
Click once on the „Yes‟ button on the warning pop-up window to start formatting the SanDisk card.
10.
Click once on the „Close‟ button on the Format window to complete the process.
SPECIFICATIONS
Laser type:
Green Laser: Diode Pumped Solid Stated Laser (DPSSL)
Red Laser: Semiconductor Diode Laser
Laser class:
Class IV
Laser life:
>5000 Hours
Cooling
forced fan Air-cooled.
Colour:
Red 140mw @650nm
Green 120mw @532nm
Laser output:
260mW (Red 140mw @650nm, Green 120mw @532nm)
Scanner system:
25Kpps
Optical angle:
±20°
Control mode:
Sound active/Auto mode
DMX512 compatible (10channels)
Playback of ILDA laser show files in SD card (channels)
ILDA 25-pin Interface for PC controller
Power supply:
AC 110-240V 50/60Hz
Power consumption:
<300W
Dimensions:
W200mm ×H260 mm ×D310 mm
Net Weight:
5.5 Kg