KAM Laserscan 300 3D Instruction Manual - page 4
Proper laser set up &usage
This fixture has been designed to be hung. It is recommended for safety purposes,your lighting effect are properly mounted using a
suitable hanging clamp andsafety cable. Items appropriate for safe and effective mounting are easilysourced from your lighting
vendor.
International laser safety regulations require that lasers must be operated in thefashion illustrated below, with a minimum of 3
meters (9.8 ft) of vertical separationbetween the floor and the lowest laser light vertically. Additionally, 2.5 meters ofhorizontal
separation is required between laser light and audience or other publicspaces.
Front Panel
1. Laser output – Laser output aperture
2. Power – Main power indicated LED. Red is ON
3. Music/IR – Synchronize to detected music signal / IR indicator
(flashing for each signal received)
4. IR – Infrared remote receiver
5. Cooling fan – cooling the unit. Never cover this fan outlet
6. Hanging bracket – 2 knobs on each side to fasten the unit
and a mounting hole to fix a mounting clamp.
Rear Panel
7. Switch – Switch on and off the power
8. Mains input – with socket and intergrated fuse holder
9. Key switch
10. Interlock – For emergency laser stop
11. LED function display
12. Safety eye – Attach the safety cable
13. DMX input - 3 PIN Male XLR
14. DMX output – 3 PIN Female XLR