KAM Laserscan 300 3D Instruction Manual - page 5
Operating Mode
When the laser is powered on, the LCD monitor on rear panel shows the current operating standalone mode, DMX address or
Slave mode. With help of the LCD control panel, it is very easy to set and change the operating mode of the laser. The next time
the laser is powered on it will show the last setting used before the laser was powered off.
Mode Option, to choose the operating mode of laser.
Confirmation, to confirm the selected mode.
UP/DOWN, to change operating mode, parameter or DMX address.
Operation
Display
Stand alone mode pre-programmed effect
Aut
Automatic show with slow effect
Sou
Sound activated show
ATTENTION! In pre-programmed standalone MUSIC SHOW mode, the laser beam will black out in 3 seconds without AUDIO /
MIC activated signal.
DMX MODE
Press FUNC to enter the MODE selection
The LED panel will show 001 for DMX mode
Press ENTER to confirm the setting
Now the laser is working in DMX mode.
Use the up/down buttons to select the DMX address
001 - 496.
Note: In DMX MODE, once the DMX cable is connected to the laser and DMX controller, the DMX LED on the front panel will be
ON.