KAMA KM2V80 Operation manual - page 17
3.3 Supplying the Lube Oil
Supply the lube oil to the specified level as below:
1. Correct the engine position to become level.
2. Remove the yellow cap of the oil filler port on the side of the engine.
3. Check the oil level with the mark on the dipstick (level gauge). Oil should be
filled to the upper limit on the dipstick.
Lube oil capacity: 2.27L
Manually tighten the cap of the oil filler port.
-
-
refueling
Fuel filter
Oil dipstick
Refueling base
4.6 Taking care During Long-term Storage
when the engine is to be stored for a long time, take the following care.
4.6.1 Inspection and maintenance during long-term storage
1. Periodic check
If the next periodic check is drawing near, carry out the inspection before storage.
2. Draining of cooling water
If no autifreeze is added to the cooling water, be sure to drain the water from the
inside of the engine.
Precautions at draining hot water to prevent scalding
Wait until the temperature goes down before draining
cooling water. Hot water may splash to cause scalding.
1) Remove the radiator cap.
2) Loosen the clamp at the lower part of the cooling water hose and disconnect
the hose. Cooling water will be drained.
3) After fully draining water, reconnect the cooling water hose and tighten the
radiator cap.
DANGER
-
-
Clip
Water hose