Kango 810 Service And Repair Manual - Service and Repair Manual
21
Service and Repair Manual
Model 810V
Fitting the
armature
assembly
1.
Fit armature assembly (114).
2.
Fit brush carrier (121) and connect two wires.
3.
Fit motor cover (110) and secure using four
screws (111),
tighten to 33 in/lbs (4Nm) torque
.
Note
: Ensure the brush carrier (121) is fitted the
correct way (brushes (123) facing down,
towards the motor cover (110)).
1.
Fit the following items onto the belly shroud
(101):
- shift disk assembly (107)
- torsion spring (106)
- two compression springs (104)
- two balls (105)
2.
Fit rotostop knob assembly (103).
3.
Fit O-ring (109) and secure rotostop knob
assembly (103) using circlip (108).
4.
Fit belly shroud (101) to the tool and secure using
four screws (102),
tighten to 28 in/lbs (3Nm)
torque
.
Note
: Roto stop assembly (103) must be in the
centre position to locate into crankcase
(275).
Assembling
the belly
shroud
118
121
114
110
111
109
108
105
107
101
102
106
103
104
Fig. 35
Fig. 36