Kango 810 Service And Repair Manual - Service and Repair Manual
11
Service and Repair Manual
Model 810V
Dismantling
the barrel
assembly
1.
Remove two screws (272) and barrel (273).
2.
Remove the following items:
- ram (271)
- O-ring (266)
Dismantling
the spindle
assembly
Dismantling
the clutch
assembly
1.
Remove oilseal (254) from intermediate housing
(257).
2.
Remove circlip (256).
3.
Press out the following items:
- bearing (258)
- thrust washer (259)
- four belleville springs (260)
- thrust washer (259)
- bearing (261)
4.
Remove four drive pins (264).
5.
Remove the following items:
- spindle extension (262)
- O-ring (263)
- O-ring (266)
- striker (267)
- cushion washer (268)
- damping washer (269)
- thrust washer (270)
1.
Remove two screws (216), bearing retainer (217)
and clutch tube (218).
Note:
Note the position of selector hole in clutch
tube (218).
2.
Remove retaining clip (232), remove hollow
clutch shaft assembly (229) and press off bearing
(230) and bevel gear (231), remove bearings (228)
from hollow clutch shaft (229).
3.
Remove spring flange (227), spring (226), splined
clutch plate (225), fixed clutch plate (224), 12
steel balls (223) and shift ring (222).
4.
Press off bearing (220) and clutch pinion (219).
261
259
259
258
256
263
264
260
265
262
273
266
275
271
272
228
216
222
229
217
223
228
218
224
230
219
225
231
232
226
220
275
221
227
254
257
266
267
268
269
270
Fig. 15
Fig. 16
Fig. 14