Kango 810 Service And Repair Manual - Service and Repair Manual
7
Service and Repair Manual
Model 810V
DISMANTLING
Important!
Before carrying out any repairs, the saw should be checked for electrical safety and for mechanical
performance. For electrical safety the saw should be placed on a non-conductive surface which is either of a
wooden construction (with the mains supply disconnected) which contains no metal parts or a bench which
is insulated by a rubber mat. The saw should then be checked by high voltage flash testing. On completion
of dismantling procedure all electrical components should then be checked for electrical safety. The saw
should
ONLY
be functionally checked if the unit passes the electrical safety test.
Removing the
belly shroud
1.
Remove four screws (102) and the belly shroud
(101)
(tap off using small screwdriver).
2.
Remove O-ring (109) and circlip (108).
3.
Remove following items:
- rotostop knob assembly (103)
- two balls (105)
- two compression springs (104)
4.
Remove following items:
- shift disk assembly (107)
- torsion spring (106)
Dismantling
the armature
assembly
1.
Remove bearing cup (112) and bearing (113).
2.
Remove fan (115).
3.
Remove bearing (117) and retaining ring (116).
Removing the
armature
1.
Remove four screws (111) and the
motor cover (110).
2.
Disconnect two wires, release retaining clip and
remove brush carrier assembly (121).
3.
Remove armature assembly (114).
109
108
105
107
101
118
121
114
110
111
117
116
114
115
113
112
102
106
103
104
Fig. 1
Fig. 2
Fig. 3