Kaption Audio 570-DZR1200X1 Owner's Manual - 1. Speaker Terminals
Controls and wiring locations
1. Speaker Terminals
Terminals outputs to amplifier. See wire diagrams for the type of sub-
woofer the amplifier will be connected to.
2. +12 Volt Power connection.
Th amplifier must be connect to the positive terminal on the vehicle’s
battery. A fuse must be connected in-line between the amplifier and
the battery. See installation instruction for further details.
N
OTE
: W
E
dO
NOT
rECOmmENd
ThE
UsE
Of
CCA (C
OppEr
C
lAd
A
lUmINIUm
)
WIrE
IN
CAr
AUdIO
INsTAllATIONs
. A
lUmINUm
Is
CONsIdErABly
lEss
CONdUCTIvE
ThAN
pUrE
COppEr
ANd
CAN
OvEr
hEAT
.
3. REM (Remote Turn On)
To turn the amplifier on/off, controlled by the source unit. This
terminal must be connected to the source unit’s “remote” or “electric
antenna” wire or connection. (See connection section)
4. GND
The ground wire from this connection must be directly attached to
bare metal on the vehicle‘s frame. The connection point on the frame
must be stripped of all paint to make a proper electrical connection.
The distance to the ground should be as short as possible and no more
than 18”.
dO NOT
CONNECT
ThE
AmplIfIEr
TO
ThE
vEhIClE
’
s
BATTEry
grOUNd
TErmINAl
.
193
7.58
61
2.40
8.74
222
154
6.06
2
1
3 4
7
8
12
13
11
10
9
6
5
- 4 -
Mono Block Amplifiers