Kaption Audio 570-DZR1200X1 Owner's Manual - page 8
Use the high level output from the source unit and the HIGH LEVEL-IN
ADAPTER supplied with the amplifier. Splice the source unit speaker
wires to HIGH LEVEL-IN ADAPTER’S terminal block on the adapter. Be
sure to connect the car audio’s system (+) wiring to the terminal block
(+) and the (-) car audio system to the (-) terminal block for each the
LEFT (L) and RIGHT (R). Plug the HIGH LEVEL-IN wire adapter into the
amplifier. Set the AS selector switch (item 9) to the “HI” position.
Power Terminals - Please take proper measures during installation to
protect the power wires as best you can. For example, when running
the power cable from the vehicle’s battery through the firewall, use
a firewall bushing for protection. Run the power wire through the
interior of the vehicle, under the carpet, and to the amplifier. If this
is something that you do not feel comfortable doing, please ask a
professional to help you. Be sure to lay the power wire away from all
signal cables.
• +12V (Item 2): This is the main power input for the amplifier and
must be connected directly to the positive terminal of the car battery
for the amplifier to operate properly. It is important that a main fuse is
installed a maximum of 8” from the battery.
High Level In adapter wire setup
High Level In adapter
- 7 -
Mono Block Amplifiers