Kaption Audio 570-DZR1200X1 Owner's Manual - 10. Rca Input Jacks
10. RCA Input Jacks
RCA Input jacks are for use with source units output signal. Source
units with an output signal level of minimum 200mV may be used.
(See wiring diagrams)
11. Wired Bass Remote Jack
Provides a wired remote control to the drivers seated location. The
Bass Remote controls the amplifier’s volume adjustment.
12. Power Indicator
The LED indicates the amplifier is functioning properly when the
LED is lit.
13. Protection Indicator
The LED will light up red and will flash if there is a fault detected by
the amplifier. Disconnect the amplifier. Check and fix the connections
to resolve the fault condition.
Connections
B
EfOrE
CONNECTEd
ANy
pArTs
Of
ThE
spEAKErs
,
ENsUrE
ThE
spEAKErs
ArE
NOT
ENErgIzEd
ANd
ThAT
ANy
INpUT
sOUrCE
Is
sWITChEd
Off
.
1. Input - (Item 10) Be sure to lay the signal wire away from all
power cables and vehicle computers. Use high quality twisted pair
interconnect cables to decrease the possibility of radiated noise
entering the system.
If the source unit is not equipped with RCA outputs, The
570-DZR600X1 amplifier can be connect to the source unit to the high
level (speaker connection) by following the high level setup below.
• LOW LEVEL: Using RCA Connections (Low level input): If the source
unit has RCA outputs, simply attach a signal cable from the source
unit to the amplifier’s RCA input. On the 570-DZR600X1; Set the AS
selector switch on the (item 9) to the “LOW” position.
• HIGH LEVEL: The 570-DZR600X1 model amplifier features current
sensing technology with the left channel input. The REM (Item 3) wire
connection is not required with the AS selector (Item 9) set in the high
position.
- 6 -
Mono Block Amplifiers